Air Guard attic keeps the moisture in the upstairst at Bay and protect against moisture damage. The system consists of two control units, a heating cable and a fan. Sensors measure the relative humidity inside and out, as well as temperature. By comparing the climate parameters in and out can control units determine when there is a need to initiate fan or heating cable. This system maintains the relative humidity in the attic down to a level that does not provide conditions for fungal growth.

What is climate watch, the loft?

Air Guard lofts is a system that monitors temperatures and drying out the Attic rooms to protect the wood against fungal attack in the attic and other moisture damage. Air Guard loft has one or more control units, which by means of temperature and moisture sensors register the climate in the attic and outdoors.

Normally varies a lot of moisture out during periods when most problems with increased moisture in the attic. During periods when the outside air is drier than the air in the attic loft only uses Air Guard fan to blow air into the attic and thus lowering the humidity there. During periods when the air in the attic is drier than the outside air's vifta. It should be damp looking as long as there is the danger of condensation and mould infestation in the attic, the system will automatically activate the heating cable. It used advanced management of cable to add just as much heat as needed to reduce the relative humidity in the attic below the danger threshold of fungus attack. Energy consumption is often low-typically 300-400 kWh per year for a loft of normal size, but can vary widely depending on. the geographical location.

Air Guard loft suitable for installation in attic rooms in both new construction and existing buildings. If there are existing fungi attack on the attic there must saneres before Air Guard lofts. Air Guard lofts will prevent the problem comes back. Energy consumption is usually several times lower than when using traditional sorpsjonsavfuktere.

Air Guard for lofts of all sizes

Air Guard lofts Start -contains only a regulator and a fan. Used to avfukte the House with an attic floor or with sideloft.

Air Guard loft Classic -contains two regulators, a fan and a heating cable. Avfukter loft in the House with one plane as one large Attic rooms.

Air Guard loft Extra -includes three regulators, two fans and a heating cable. Avfukter larger loft in the House with one and a half level that can have multiple separate Attic rooms. This loft is often in houses with tillbygg.

Technical information
Approved installation area: EU Member States
Production norms: Meet product standard for products within the EEA, particularly Machine Directive (98/79/EG) electromagnetic compatibility directive (89/336/EEG, 92/31/EEG, 93/68/EEG, 98 13/EG) and low voltage Directive (73/23/EEG, 93/68/EEG) connection: 220V AC +/-10%, 50-60 Hz
Max power consumption: 470 W, 2.1 A
Temperature, anvendingsområde:-40 oC to + 40 oC
Temperature, storage:-40 oC to + 80 oC
Corrosion resistance: Very good.
Life: during normal operation, over 50 years. The fan needs to be replaced more often
Warranty: 3 years from date of delivery
Calibration interval: Under normal use does not have the device calibrated in his lifetime.
Maintenance interval: Under normal use, the device does not need maintenance, but a Visual inspection of the
Air Vaktens light indication should be done before and after the winter. Make sure the device is in operation (green light) and that this capacity don't alarm blinks. The fan needs cleaning, or needs to be replaced.
Protection class: IP 40, the unit should be mounted indoors.
Environmental factor: Air Guard is a more environmentally friendly alternative to traditional sorpsjonsavfuktere, both in the production, use and recycling. Air Guard recovered as electronics and shipped to recycling. Material in the Air Guard is PVC plastic, ABS plastic, glass, copper, Phenol-plastic and Tin. Small amounts of other metals.